Ketzer
Good news, everyone!
So, I've got this Pod Pro, right, and just got a Behringer FCB1010. I have a number of presets saved into the pod, and now, I want to control them using the FCB. Unfortunately, I don't think this is the kind of thing I can learn by trial and error, and while I know it can be done, There must be some trick to doing it right. I found a PC editor program for the FCB, which allows me to map the buttons and banks to different signals, etc, but that's not quite enough, I don't think.
Is there a similar program for the Pod? It's an original Rackmount Pod Pro, not sure of the firmware. I assume it's 2.0, though I haven't checked.
Or is there some other way of doing this that I haven't even thought of? I think I may have inadvertently bit off far more than I can chew at one time.
Is there a similar program for the Pod? It's an original Rackmount Pod Pro, not sure of the firmware. I assume it's 2.0, though I haven't checked.
Or is there some other way of doing this that I haven't even thought of? I think I may have inadvertently bit off far more than I can chew at one time.