Using Pod X3 with Flat Response Headphones..

[Riffmagus]

I'm using my POD X3 with a pair of Audio Technicia ATH-M50 cans....

I have been able to get a decent tone/s out of my six strings - but my 8 is going to take some tweaking. What sounds good @ quiet levels, when cranked becomes an unusable beast - and shit to boot.

Is it best to run the X3 into my Endirol interface - and crank it literally FULL BORE - and run my cans out of that - and dial in the tone that way? Then I just have to sort out 2 patches per tone - one for recording and one for late night jamming through 'phones.

Then again - I am in a bit of a grumpy mood - so what sounds shite today could be sonic gold tomorrow..

 

[VettaUser]

For recording, I would listen to the patch through what most people would hear it through, speakers. And then I'd check with the headphones as well.