Post your pedalboard

[Crungy]

@wheresthefbomb I've been using a BD2 into a Behringer SuperFuzz and that gets gnarly. An SD1 into a BD2 also fucking rips.

 

[MatrixClaw]

My board is currently all over the place, but I'm planning on selling a bunch of stuff and downsizing to 5 pedals:

TC Polytune 3 mini, Strymon Sunset, Ibanez PTEQ, Strymon BigSky or SA Ventris, SA Collider (dual delay mode)

Also might get a compressor but we'll see. Waiting to sell some stuff so I can buy a Deluxe Reverb and decide if I need it. I also might keep my Dirty Tree around just in case, since the Sunset can't do the TC sound, but I also don't really use it now, so maybe not.

 

[TheWarAgainstTime]

@TheWarAgainstTime thought about grabbing an axefx ii/iii for effects with the gcx instead?

I tried doing a 4CM setup for a while with my old Axe-FX II, but ultimately preferred the simplicity and particular sounds I've got set up with my pedals if I'm already using a real amp and cab anyway I just got along best with the workflow of using the Axe-FX as an all-in-one solution for recording direct or running through a solid state power amp and cab as a separate full rig.

 

[budda]

I tried doing a 4CM setup for a while with my old Axe-FX II, but ultimately preferred the simplicity and particular sounds I've got set up with my pedals if I'm already using a real amp and cab anyway I just got along best with the workflow of using the Axe-FX as an all-in-one solution for recording direct or running through a solid state power amp and cab as a separate full rig.

Nice

 

[DECEMBER]

DECEMBERmusic.org
And this new release with the Natas or the Precision Drive in front of tube amp distortion, and just about all the mods/delay/reverb except the Slicer and tremolo:

 

[Guitarmiester]

I have two boards. The first is my acoustic board which is small and simple. The second is my main board for electric. It's a work in progress. The latest addition was the EQD Bellows. The board is due for rearranging and maybe an addition or two. I run this in front of my Mesas and don't bother with wiring anything for the effects loop.

I'm thinking of adding one of my delays back into the mix. It's a tough call between my EQD Disaster Transport, Empress Tape, Empress SuperDelay or the classic Boss DD20.

 

[wheresthefbomb]

@guitarmeister Disaster Transport always gets my vote! I was unfortunately less than wow'd by the Empress Tape, but I was looking for it to do some very specific things. The friend I sold it to loved it.

@DECEMBER What Carvin amp is that controller for? Reminding me of my old VL100, I loved that amp. Dig your track, especially the melody coming in around 0:45, sounds like ebow and maybe some reverb into dirt magic?

 

[budda]

@guitarmeister can i make it worse and add the diamond memory lane jr?

 

[Guitarmiester]

@guitarmeister Disaster Transport always gets my vote! I was unfortunately less than wow'd by the Empress Tape, but I was looking for it to do some very specific things. The friend I sold it to loved it.

The Disaster Transport is most likely what will land on the board. Lack of tap tempo has been my only reserve otherwise it'd be a no brainer. I've also been curious to try out the Disaster Transport reissue although I've heard it lacks the darker character of the original.

The Empress delays are really nice. I used them for years before I pulled all delays off my board. The darker characteristics of the Disaster Transport give it the edge over the Empress especially for running them in front of an amp.

@guitarmeister can i make it worse and add the diamond memory lane jr?

I had a feeling that recommendation would pop up. That's one delay that's always been on my radar but never bought it. I already have an excessive amount of delays and reverbs on hand so I should probably bite the bullet and finally give the Diamond a try.

 

[budda]

I had the jr and it sounded really good. And solidgoldfx now makes Diamond pedals again to boot.

 

[DECEMBER]

@DECEMBER What Carvin amp is that controller for? Reminding me of my old VL100, I loved that amp. Dig your track, especially the melody coming in around 0:45, sounds like ebow and maybe some reverb into dirt magic?

It's a Carvin V3, 3-channel 100W. Thanks for listening! I do use an eBow quite a bit, but not in this song. That first guitar part starts with strumming an open D chord in drop-D then bringing up the volume knob from 0. It's got a self-oscillating delay with a filter sweep modulation effect from the Nemesis and the Digitech FreqOut making the feedbacky sustain.
There are a few layers of the opening volume swell with different guitars and the feedback sustain of the last note, because I wasn't getting a smooth volume swell with the A25k pot on my current guitar with EMGs, so I mixed in the swell from an old take I did with a B500k pot on passive pickups. And the FreqOut is inconsistent, does some really cool things sometimes that you can't get it to do again. Some old takes that sounded pretty bad had the best volume swell and feedback, so I mixed them in with a new take.

 

[guitar_player4_2_0]

Does this count?

View attachment 138987

First time you post without a bad ass sitting beneath your gear I’ll know it’s not really you lol.

 

[sonoftheoldnorth]

DIY board from stuff laying around. Need some feet to get it off the floor a little more and then done... For now.

 

[4Eyes]

Apparently my fingers slipped and ordered something on Reverb.com, now I have to wire it up and pretend it was always there, since the board sits on my desktop

Damn GAS

 

[wheresthefbomb]

DIY board from stuff laying around. Need some feet to get it off the floor a little more and then done... For now.

Darkstar

 

[MatrixClaw]

Working on wiring this up today. More pedals on here than I plan to keep, but wanted to shootout some ODs while I have space. Still need an HX Stomp for time based stuff but haven't found one for a reasonable price yet.

 

[MatrixClaw]

Picked up a Pedaltrain Fly board for a great price on TGP. Kicked a few pedals off the board and I'm still waiting on two, plus I have the Sunset listed... But this is looking much prettier now:



...I also need a full set of matching patch cables Also, I just ordered the Pedaltrain mount for my Cioks DC7 and Crux, so I don't have to Velcro them to the bottom.

 

[budda]

I had a cioks.. dc10? And appreciate my trutone coming with mounting brackets lol.

 

[wheresthefbomb]

I had to use backpack straps to mount my Walrus Audio Pheonix to my Pedaltrain Classic Pro. I'll eventually get some metal strips to do it proper, but they work surprisingly well.

 

[budda]

Swapped the reverb for my new tremolo pedal for tonights jam.